Micromod Micro-DCI: 53SL5100A Single Loop Controller Instrukcja Użytkownika Pobierz pdf (Strona 68)

Single Loop Process Controller Instruction Manual

60 Single Loop (PID) Controller

5.3 Single Loop Controller Parameter Selections

Figure 5-4 illustrates how a Single Loop Controller would appear with only the default values and power

applied, but no analog input or output signals. In Figure 5-5, ANO0 (TB1-10) is jumpered to ANI0 (TB1-2)

to simulate process operation. The unit has the AC power supply and power cord 173D109U03.

Connecting ANO0 to ANI0 is done only for illustration purposes and is not necessary to configure the con-

troller. If the controller is connected to a Datalink network, then assign the Instrument Address (B001) and

Baud Rate (B002) first, so the remaining datapoints may be entered at the SUPERVISOR-PC unit. After

this section, refer to Section 9 to configure the parameter display datapoints. The parameter display is

accessed by pressing the F2 pushbutton from this display. Also, refer to Section 10, Instrument Tuning,

(Instrument Tuning) or Section 11, EASY-TUNE, to set the operating performance parameters: Propor-

tional Band (C106), Reset Time (C107), and Rate Time (C108). All other datapoints not shown in the illus-

tration are at the default value.

Figure 5-4. CS1 Datapoint Selections (A)

Figure 5-5. CS1 Datapoint Selections (B)

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 151 152

Brak uwag

Micromod Micro-DCI: 53SL5100A Single Loop Controller Instrukcja Użytkownika Strona 68