Micromod MOD: 30ML Operation and Template Setup Instrukcja Użytkownika Pobierz pdf (Strona 64)

MOD 30ML Operation

APPENDIX A - EVENT CODES

A-2

Table A-2. Event Codes, Description and Action

Block

Type

Codes Full Message Text Description/Action

AIN 4 I/O COMMUNICATIONS ERROR Diagnostic report of a communications problem.

AIN 5 AIN (MODULE) ERROR Output circuit reported an output too low or too

high error.

AIN 6 MODE SET TO AUTO Information only.

AIN 7 MODE SET TO MANUAL Information only.

AIN 8 CJC MODE SET TO AUTO Information only.

AIN 9 CJC MODE SET TO MANUAL Information only.

AOM 4 BLOCK MODE SET TO AUTO Information only.

AOM 5 BLOCK MODE SET TO MANUAL Information only.

AOM 6 I/O MISMATCH A configured slot is either empty or the installed

module does not match the slot configuration.

AOM 7 AO COMMUNICATIONS ERROR One of the following conditions was detected:

• There is a checksum error in the

communications between this block and the

module.

• The select circuit, which is used to

communicate with the module, has a

diagnostic error. In this case, all modules

report a communications error.

AOM 8 AO MODULE ERROR The module has reported an error which is

identified by an extended error code. The error

codes can be viewed via the Extended Error

(EXTERR).

AOUT 4 BLOCK MODE SET TO AUTO Information only.

AOUT 5 BLOCK MODE SET TO MANUAL Information only.

AOUT 6 AOUT COMMUNICATIONS ERROR Diagnostic report of a communications problem.

AOUT 7 AOUT (MODULE) ERROR Output circuit reported an output too low or too

high error.

CJI 0-4 See TI 0-4.

CJIM 4 BLOCK MODE SET TO AUTO Information only.

CJIM 5 BLOCK MODE SET TO MANUAL Information only.

CJIM 6 I/O MISMATCH A configured slot is either empty or the installed

module does not match the slot configuration.

CJIM 7 I/O COMMUNICATIONS ERROR One of the following conditions was detected:

• A checksum error in the communications

between this block and the module.

• The select circuit, which is used to

communicate with the module, has a

diagnostic error. In this case, all modules

report a communications error.

CJIM 8 CJC MODULE ERROR The module has reported an error which is

identified by an extended error code. The error

codes can be viewed via the Extended Error

(EXTERR).

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 83 84

Komentarze do niniejszej Instrukcji

Brak uwag

Micromod MOD: 30ML Operation and Template Setup Instrukcja Użytkownika Strona 64

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Micromod MOD: 30ML Operation and Template Setup